Weller D650 User Manual download pdf (Page 4)

STYLE 2

1. Loosen set screws with supplied hex key.

2. Pull tip from gun.

3. Slide new tip into gun until it bottoms out.

4. Tighten set screw.

TROUBLE SHOOTING:

Soldering Gun doesnt heat properly:

If your Weller

Soldering Gun appears to be heating, but not hot enough to

perform the job, try loosening and re-tightening the tip. It may become

necessary to clean the connecting area of the tip ends with sandpaper or

possibly install a new tip. (Refer to Replacing Tips section). A good

electrical connection between the tip and the soldering gun is essential for the

tool to heat properly.

Light bulbs dont light up:

Try tightening the bulbs in the sockets. If problem still persists, then

replacement bulbs can be purchased. (Part # 7333).

1 2 3 4

No comments

Weller D650 User Manual Page 4